Autowatch immobilizer bypass and tag programming

Mar 4, 2012   //   by admin   //   Tech Tips  //  Comments Off on Autowatch immobilizer bypass and tag programming


ENTERING THE EMERGENCY OVERIDE NUMBER
Refer to the 5 digit number on the key tag. Each digit is entered individually using the ignition
switch. As a comprehensive guide of how to enter the number, the following example shows how
the override code number ‘45032’ would be used. Note that a ‘0’ is represented by 10 flashes).
1. While the light is flashing (because the immobiliser is armed) turn the ignition ON. The
light will turn steady ON.
2. Turn the ignition OFF, and the light will start flashing. Count the number of flashes.
After the 4th flash, turn the ignition on. The light will be steady on again (This is the first
digit entered).
3. Turn the ignition OFF, and count the flashes. After the 6th flash, turn the ignition ON.
The light will be steady on again. (This is the second digit entered).
4. Turn the ignition OFF, and count the flashes. After the 10th flash, turn the ignition ON.
The light will be steady on again (This is the third digit entered).
5. Turn the ignition OFF and count the flashes. After the 3rd flash, turn the ignition ON. The
light will be steady on again (This is the fourth digit entered).
6. Turn the ignition OFF, and count the flashes. After the 2nd flash, turn the ignition ON.
The light will flash rapidly to indicate that you have successfully entered the code and the
immobiliser will disarm allowing you to start the vehicle.
To Code New Transponder tag
When the LED light is flashing, turn ignition key on and the LED light will be constant. Turn key
off and count the flashes of your first number of your over ride pin code, turn key on then off and
count second number and repeat procedure for the rest of your numbers. If you have a 0 number
then this counts for ten flashes. When you have reached the last number of your 5 pin code the
LED light will rapidly flash, turn key off and count one flash, turn key on then off and count
another one flash. Turn key on and introduce the transponder tag and then repeat again after two seconds.
The LED light will rapidly flash for acceptance. Your transponder tag is then coded.

Comments are closed.